VEIRA Vocal Rider
What does VEIRA Vocal Rider do?
It rides the vocal’s fader for you, the way an engineer rides it through a song. You set TARGET, where the vocal should sit in LUFS, and one console fader moves up and down to keep it there: quiet lines come up, loud ones go down, within RANGE DOWN and RANGE UP. It changes the level smoothly, like a hand on the fader, not the sound of the voice.
How do I set TARGET?
Play a loud part of the song and turn TARGET (or drag the green line on RIDE) until the vocal sits where you want it over the music. Start near the vocal’s own level so the fader centres near 0 dB: a vocal recorded with peaks around −6 to −10 dBFS usually sings at about −20 to −16 LUFS. If the fader sits at one of its stops all the time, TARGET is far from the vocal’s level: move it towards the amber trace, or widen the range.
Will it lift breaths and the noise between phrases?
No. The fader holds still in pauses, in the tails of words, on an “s”, “t” or “f” and on breaths, and under IGNORE BELOW. Set IGNORE BELOW (the red dashed line on RIDE) under the quietest singing and above the noise between phrases, about 20 to 30 dB under TARGET. If the fader still creeps up in the pauses, raise it.
What does SPEED change?
How quickly the fader follows: low settings ride whole phrases, high ones ride words. If you hear the level move within a phrase, lower SPEED; if whole lines still come out too loud or too quiet, raise it. The fader always turns down twice as fast as it lifts, and a sudden jump of more than 3 dB is caught in 5 ms.
Does it add latency?
With LOOKAHEAD on (the default), 25 ms: 1,200 samples at 48 kHz. Your DAW is told and compensates, so the vocal stays in time, also when the plugin is bypassed. LOOKAHEAD lets the rider hear a loud first word before it plays. While recording or monitoring a live voice through the plugin, switch LOOKAHEAD off for zero latency, or use the preset Live Stream No Latency.
How do I record the ride as automation?
Show the track’s automation for Fader (the FADER parameter) and put the track’s automation mode in Touch, Latch or Write. Press WRITE on the rider and play the song: your DAW records every move, about 30 points a second. Then set the track’s automation back to Read and press READ: the fader plays the automation back, and you can edit the lane or drag the fader by hand.
Should it go before or after my compressor?
Before. The rider evens out the lines, so the compressor after it sees the same level all song long and can be set gently. The rider ignores sibilance, so a de-esser can go before or after it. For bass, use VEIRA Bass Rider, which listens to low notes and lets their decays ring.