VEIRA Overdrive
What is VEIRA Overdrive for?
It is a drive pedal for any track, not only a guitar. Three pedal circuits sit behind one slide switch, OVERDRIVE, DISTORTION and FUZZ, with DRIVE, TONE and LEVEL on the big knobs. BODY, FOCUS and MIX are what make it work on drums, basses, keys, voices and whole mixes: BODY keeps the lows clean, FOCUS sets where the drive starts and MIX blends the driven sound with the clean one. Put it on a track or a bus as an insert.
How is it different from VEIRA’s saturators and from VEIRA Mod Drive?
VEIRA Saturator, the four colour saturators (White, Red, Gold and Blue), VEIRA Harmonic Saturator and VEIRA Tape Saturator are studio processors that add harmonics to warm, thicken or glue a sound. VEIRA Overdrive is a stomp box: three pedal circuits, six knobs and a footswitch, made to go from a light push to a full fuzz. VEIRA Mod Drive is a drive into a modulation pedal (chorus, flanger, phaser, tremolo or vibrato); VEIRA Overdrive has no modulation and gives you three circuits, BODY and FOCUS instead.
Which CIRCUIT should I choose?
OVERDRIVE clips softly beside the clean sound, so it follows how hard a part is played and pushes the mids; at DRIVE 0 % it is the input. Start there for buses, vocals, bass and guitar. DISTORTION drives against a firm ceiling with a short knee: thicker, more compressed, sustaining, for snares, leads, organs and parallel layers. FUZZ has two unequal halves and a bias that follows the drive: even harmonics and a buzzing pulse when pushed, for bass lines, room microphones and effects. The switch crossfades over 20 ms, so you can change it while the music plays.
What do BODY and FOCUS do?
BODY keeps the lows clean: everything under it, from Off (20 Hz) to 400 Hz, goes around the circuit untouched through a 24 dB/oct crossover. Use it on kicks, basses and mixes so the low end stays solid. FOCUS, from 80 Hz to 2 kHz, sets where the drive starts: each circuit drives the part of the sound above it. Higher drives the mids and highs and leaves the low end whole; lower drives the whole sound. They work together: FOCUS chooses what is driven, BODY protects what must not be.
Why doesn’t it get louder when I turn DRIVE up?
The level is matched as DRIVE rises, so you judge the colour, not the loudness: a 1 kHz tone at −18 dBFS stays within 0.02 dB from DRIVE 0 to 100 % in every circuit. Dense material is compressed more than a single tone, so heavy settings can come out a little quieter or louder than the input. That is what LEVEL is for: it sets the pedal’s output from −24 to +12 dB.
What does TONE do?
TONE is a tilt around 1 kHz after the circuit, up to 9 dB each way: darker to the left, brighter to the right, flat in the middle. Use it to the left to tame the fizz of a heavy fuzz, or to the right to help a driven bass or vocal cut through. A smoothing filter also closes a little as DRIVE rises, as a pedal darkens when it is pushed, so a small turn of TONE to the right brings the top back at high DRIVE.
How do I use it in parallel?
Turn MIX down. MIX blends the driven sound with the clean one, in time with it, from 0 to 100 %. Around 20 to 50 % a heavy DISTORTION or FUZZ sits under the clean track as a layer: try Drums ▸ Parallel Smash or Mix Bus ▸ Parallel Colour. With BODY on, the clean side of the blend takes the same crossover, so a half-and-half MIX cuts no notch at the BODY frequency.
Does it add latency, and what do the footswitch and the lamp do?
It delays the sound by 96 samples at every sample rate and setting (2.0 ms at 48 kHz) and reports it, so your DAW compensates. The footswitch turns the pedal on or off; off, it passes the input delayed by the same 96 samples, bit for bit, as do the host’s bypass and MIX at 0 %, so the track stays in time. The lamp glows a little while the pedal is on, brightens with how hard the circuit clips and is out when the pedal is off. Presets leave the footswitch where it is.
What presets does it come with?
41 factory presets in 8 folders: Default, Drums, Bass, Guitar, Keyboards, Vocals, Mix Bus and Creative FX, from Kick Punch, Snare Crack and Drum Bus Glue to Bass Growl, Edge Of Breakup, Electric Piano Bark, Vocal Edge, Bus Warmth and Blown Speaker. Each has a one-sentence note, and each preset’s LEVEL is set so the result is as loud as the bypassed track, within 0.05 dB on test material that matches its use. On hotter or quieter tracks the drive is stronger or weaker: adjust DRIVE first. You can save your own with SAVE.