VEIRA DeEss

What is VEIRA DeEss for?

VEIRA DeEss turns down the sharp “s”, “sh”, “z”, “t” and “ch” sounds of a voice while leaving the rest of the voice alone. It also works on the hard edges of instruments, such as hi-hats, pick clicks, fret squeaks and bow scratch, and on vocal sibilance inside a finished mix.

How do I de-ess a lead vocal?

Load Vocals ▸ Female Pop Vocal or Vocals ▸ Male Lead Vocal and keep RELATIVE, SPLIT and LOOKAHEAD on. Press LISTEN BAND and move LOW until the “s” sounds jump out (usually 4.5–7 kHz), switch it off, then lower THRESHOLD until the waveform turns green on the “s” sounds and the GR column shows about 4–6 dB on them. Put VEIRA DeEss after your compressor and bright EQ.

Should I use RELATIVE or ABSOLUTE?

Use RELATIVE for one voice (lead or backing vocal, speech, podcast) or a solo instrument whose level moves a lot: it measures the band against the voice’s own level, so one threshold catches the same “s” whether the singer whispers or belts. Use ABSOLUTE for anything that isn’t one voice, such as hi-hats, guitars, synths or several voices on one track; it depends on your level, so if your track is 4 dB hotter, raise THRESHOLD 4 dB.

What do SPLIT and WIDE do?

SPLIT (the default) turns down only the top of the voice through a smooth shelf starting just below LOW, so the vowels underneath are untouched; it’s the most transparent way to de-ess. WIDE turns the whole signal down while an “s” is detected, like a singer turning away from the mic, which sounds natural on some voices but can duck the start of the next vowel.

How do I read the display?

The waveform turns green wherever an “s” was turned down, and the strip along the top edge marks every cut. In the detector lane, the amber line is THRESHOLD and the red caps are what was removed; they should sit on the sibilants only, and you can drag the amber line to set the threshold.

Does VEIRA DeEss add latency?

With LOOKAHEAD on (the default) it adds 3 ms (144 samples at 48 kHz), which your DAW compensates automatically; with it off the latency is zero. For tracking, live monitoring or streaming, use Live Vocal No Latency, Live Stream Low Latency or Mix No Latency, which turn LOOKAHEAD off. LOOKAHEAD can’t be automated, so set it before you play.

Why doesn’t it cut anything?

Check the GR column: if it stays at 0, lower THRESHOLD. In ABSOLUTE mode on a quiet track the band may never reach the threshold, and in RELATIVE mode a band quieter than −65 dBFS never triggers. Also check that RANGE isn’t at 0 dB and that LOW is where the sibilance is (use LISTEN BAND).

Why does the voice sound dull or lispy?

The de-esser is cutting too much or for too long. Raise THRESHOLD, lower RANGE, shorten RELEASE or raise LOW; in the detector lane, red should appear only on the “s” sounds. If Δ INTEGRATED drops by more than 1 LU on a voice, it is probably cutting vowels too.

Why is my track suddenly quiet and thin?

LISTEN BAND or LISTEN CUT is on: they change what you hear, playing only the detector’s band or only what is removed. Click the lit button to switch it off, and remember they are saved with the session, so switch them off before you bounce.

Can I type a value, or make the window bigger?

Yes. Right-click a knob (Control-click on a Mac), type the value and press Return; double-click a knob to return it to its default. To resize the window, drag its bottom-right corner: it scales from 75 % to 200 %, keeps its proportions, and the size is saved with your session.