VEIRA Master Rack

What does VEIRA Master Rack do?

It is a whole mastering chain in one tall rack of vintage hardware: INPUT, TUBE EQ, COMPRESSOR, TONE EQ, TAPE, STEREO, LIMITER and METERS, in a fixed order from top to bottom. Set each unit from the top down and the rack takes a finished mix to a release-ready master, with VU needles, loudness, true peak and correlation to check it. It is an original design; inside are engines from VEIRA Passive EQ, Tube Leveler, EQ, Tape Saturator and Max.

Should I choose Master Rack or Mastering Suite?

Both are complete mastering chains. VEIRA Master Rack is a fixed chain of vintage hardware: eight units in one decided order, with tubes, vari-mu glue and tape colour as part of the sound, knobs, switches and needles, and no reference track. VEIRA Mastering Suite is a modern console: nine modules you can put in any order (the maximizer always last), clean and precise, with curves and spectra, and a reference track whose tone, width and loudness it can match. Choose the Master Rack for a warm, analog-style master with the decisions already made; choose the Mastering Suite to arrange your own chain and match a reference.

Can I change the order of the units?

No. As in a hardware rack, the order is fixed: the level first, broad tone (TUBE EQ), glue (COMPRESSOR), fine tone (TONE EQ), colour (TAPE), width (STEREO), then the LIMITER and the METERS. You can switch any processing unit out with its IN / OUT switch: a unit that is OUT passes the audio delayed by its latency, bit for bit, so the timing never changes, and switching crossfades over 20 ms.

How do I start a master?

Pick a preset close to your genre and loudness, or start from Default: Init. Set TRIM so the IN LEVEL meters peak near −6 dBFS on the loudest part, lower the COMPRESSOR's THRESHOLD until its needle shows 1 to 3 dB, shape the tone with the TUBE EQ and the TONE EQ, then raise the LIMITER's GAIN until INTEGRATED reads your target. Press RESET and play the whole song to check the integrated loudness and the true peak.

How loud should my master be?

For streaming, about −14 LUFS integrated at a ceiling of −1.0 dBTP: the services turn louder masters down to about that level. Acoustic music, ballads and vinyl often sit at −12 to −13 LUFS, and pop, rock, hip-hop and electronic music competing on loudness at −9 to −10 LUFS. The factory presets are tuned to these targets; set the LIMITER's GAIN until INTEGRATED reads yours.

What do the MID and SIDE modes of the TONE EQ do?

MODE sends all four TONE EQ bands to one part of the stereo picture. STEREO works on both channels alike. MID works only on what the two channels share (the vocal, the kick, the bass, the snare), so you can bring the lead vocal forward without touching the width. SIDE works only on what differs between them (reverb, wide guitars, the stereo spread), so air there makes a master feel wider. Changing the mode glides.

What do WIDTH and MONO BASS do?

MONO BASS takes the side signal out below 40 to 200 Hz with a Linkwitz-Riley 24 dB/oct split, so the kick, the bass and the sub sit in the centre: 100 to 150 Hz suits club and hip-hop masters, 150 to 200 Hz vinyl. WIDTH, from 0 to 200 %, then scales the side above the split: 100 % leaves it unchanged, more widens, less narrows. Watch the CORRELATION meter and keep it above 0.

What do the meters show?

The METERS read the rack's output. The LEFT and RIGHT VU needles show the level on VU ballistics, with 0 VU at the VU REF level (−18, −14, −12 or −10 dBFS RMS) and the RMS level in dBFS under each. INTEGRATED is the loudness since the last RESET (ITU-R BS.1770, LUFS), SHORT-TERM the last 3 seconds, TRUE PEAK MAX the highest true peak (dBTP, 8x interpolated) and CORRELATION how alike the channels are over 300 ms. The COMPRESSOR and LIMITER each have a gain-reduction needle.

Does it add latency?

Yes: the sum of its units', 640 samples at 48 kHz (13.3 ms), 618 at 44.1 kHz and 919 at 96 kHz, from the TUBE EQ's oversampling, the COMPRESSOR, the TAPE and the LIMITER. It is constant whichever units are in, reported to your DAW, which compensates automatically, and the host's bypass is delayed by the same amount. Use the rack for mixing and mastering rather than while recording.

What presets does it come with?

42 factory presets in 11 folders: Default, Pop, Rock, Hip-Hop, Electronic, Acoustic, Jazz & Classical, Loud, Streaming, Vinyl & Gentle and Creative FX, from Radio Ready and Arena Glue to Club Master, Streaming Standard, Vinyl Pre-Master and Cassette Dream. Each was tuned on premasters peaking at −6 dBFS for its compressor reduction and its loudness target, from −14 to −9 LUFS. With a hotter or quieter mix, adjust TRIM first, then the LIMITER's GAIN. You can save your own.

VEIRA Master Rack · Help · VEIRA