VEIRA Expander
What is VEIRA Expander for?
It turns down what you don’t want between the notes: the spill of other drums between the hits, an amplifier’s hum or hiss between notes, the room and the fan between sentences. The notes pass untouched. It can work gently, so the noise only sinks a few dB, or go all the way to a gate. In UP it does the opposite, making what goes over the threshold louder, to give squashed drums and mixes their punch back. You set it by eye, dragging the threshold on a scrolling waveform.
What is the difference between an expander and a gate?
A gate shuts as soon as the level falls under the threshold. An expander turns the sound down gradually: at 1:2 every dB under the threshold becomes 2, so a fading note sinks smoothly into a lower floor instead of being cut. VEIRA Expander does both: RATIO runs from 1:1 through gentle settings such as 1:1.5 to 1:8, then steeper to GATE, and RANGE sets how far down it may go, up to silence. On drums a steep ratio or GATE is often right; on pianos, voices, rooms and anything that fades, a gentle ratio sounds more natural.
How do I set the threshold?
Play the track and look at the waveform. Drag the amber THRESHOLD line, or click where it should be, so it sits just over the noise in the gaps and under the quietest note you want to keep; double-click for −40 dBFS. The teal detector line should cross the threshold on every note and stay under it in the gaps. THRESHOLD is the one setting that depends on your track’s level: the presets assume typical recording levels, so if your track is 6 dB hotter, raise it by 6 dB.
It chatters or cuts off the ends of notes. What helps?
Chatter, a flutter as a note fades, means the level hovers at the threshold: raise HYSTERESIS to 4 to 6 dB (it then closes only that far under the threshold) and add HOLD. If the ends of notes are cut, lower THRESHOLD, lengthen HOLD or RELEASE, or turn on AUTO RELEASE, which releases slowly after long notes and quickly after short hits. If the start of a note is lost, set LOOKAHEAD at least as long as ATTACK: then a hit starts fully open.
What does UP do?
UP is upward expansion: it leaves everything under the threshold alone and makes what goes over it louder, (RATIO − 1) dB more for every dB over, up to MAX BOOST (24 dB at most). Set THRESHOLD a little under the hits of a compressed drum bus or mix and their punch comes back. A CEILING on the final output means no boosted peak ever passes it, and it never turns anything down; a negative OUTPUT gives the boost more room under it. The Upward presets do this and turn OUTPUT down 2 to 4 dB to keep the level about where it was.
How do I use another track as the key?
Turn EXT KEY on and route the other track to the plugin’s sidechain input, called the key input in some hosts. Hosts do this in one of three ways: a sidechain menu at the top of the plugin’s window where you choose the track; a sidechain input you switch on in the plugin’s header and then feed with a send from the other track; or the plugin’s input pins 3 and 4. The teal detector line then follows the key track. With nothing routed there, it listens to its own track. The Creative FX presets Keyed Pad Pump and Keyed Stutter work this way.
What do KEY LOW and KEY HIGH do?
They filter what the expander listens to, never what you hear. KEY LOW is a high-pass from Off (20 Hz) to 2 kHz, so lows such as a kick, rumble or hum can’t open it; KEY HIGH is a low-pass from 100 Hz to Open, so hi-hats, cymbals and hiss can’t open it. Both are 24 dB per octave. Turn LISTEN on to hear the key while you set them, then turn it off; an offline bounce always leaves LISTEN out. The snare presets, for example, listen between 150 Hz and 4 kHz.
Does it add latency?
Yes, always 10 ms, whatever you set: 441 samples at 44.1 kHz, 480 at 48 kHz, 960 at 96 kHz. LOOKAHEAD works inside that delay, so changing it never changes the latency. VEIRA Expander reports it to your DAW, which compensates, and the host’s bypass is delayed by the same amount, so the track stays in time. When it has nothing to do (RATIO 1:1, RANGE 0, MIX 0 % or the sound over the threshold) and OUTPUT is at 0 dB, the output is the input, delayed, bit for bit. For playing or singing through a track while recording, bypass it until you mix.
What presets does it come with?
55 factory presets in 11 folders: Default, Drums, Bass, Guitar, Keyboards, Vocals, Mix Bus, Mastering, Speech, Upward and Creative FX, from Kick Tighten, Snare Tighten, Toms Clean and Overheads Bleed Down to Amp Hum Down, High Gain Noise, Lead Breaths Down, Podcast Room Tone, Gap Silencer, Drum Bus Punch and Gated Snare Room. Each was measured on material with a known wanted and unwanted part. A preset sets every control except LISTEN. You can save your own with SAVE.