VEIRA EQ Gold
What does VEIRA EQ Gold do?
It is a tube program equalizer, the warm one of the four VEIRA colour EQs, painted brushed champagne gold, in the tradition of the classic passive program EQs of the 1950s. A low section you can boost and attenuate at once, a resonant HIGH BOOST with its BANDWIDTH and a gentle HIGH ATTEN sit over a mid-range section with two broad peaks and a dip, all on stepped frequencies and through a TUBE output stage. The curve screen shows each section and the total over the live spectrum.
Which of the four colour EQs should I choose?
All four draw their curve over the live spectrum, keep their curves’ analog shape up to 20 kHz and show the same meter bridge; what differs is the kind of EQ. White is clean and surgical: eight bands of any shape, SOLO and minimum or linear phase, for precise fixes and transparent mastering. Red is mid/side: every band on the stereo signal, the mid, the side or one channel, with BASS MONO, AIR and WIDTH. Gold is warm: a passive tube program EQ with the low boost-and-attenuate trick, a silky top and TUBE drive. Blue is vintage: a 1970s British inductor console EQ with stepped frequencies and COLOUR. Each manual has a page comparing them.
What is the low-end trick?
Set LOW to a frequency and use BOOST and ATTEN together. They don’t cancel: the attenuation reaches much higher than the boost, so below the frequency the boost wins and you get more weight, while a little above it you get a gentle dip that clears the mud. At 60 Hz, BOOST 10 dB with ATTEN 5 dB gives +6.0 dB at 20 Hz and a −1.2 dB dip at 550 Hz. Start with BOOST about twice ATTEN; the presets Bass Trick and Low-End Trick are ready-made.
How do I get a silky top?
Use HIGH BOOST and HIGH ATTEN together: for example HIGH BOOST at 10 kHz, +6 dB, and HIGH ATTEN at 10 kHz, 3 dB. The boost’s resonant peak keeps the shine while the long, gentle attenuation takes the harshness off above and around it. BANDWIDTH sets the peak from sharp (Q 2.2) to broad (Q 0.45), and like the hardware it narrows as you boost more. The Vocals preset Silky Female Top does exactly this.
What does TUBE do?
TUBE drives the output stage: smooth, low-order harmonics, the 2nd leading, more on loud peaks than on quiet passages, which keep their level. 10 to 25 % is warmth you feel more than hear, 30 to 50 % audible glow, 70 to 100 % an effect. At 0 % Gold is clean. It runs at four times the sample rate, so it doesn’t alias, and since it works on the EQ’s output, a big low boost drives it harder.
Why is a frequency knob grey?
Its section is at 0 dB, so the frequency doesn’t matter yet; the knob is dimmed but still readable. Turn up the section’s BOOST, ATTEN, PEAK or DIP and it lights. Every FREQ knob clicks between fixed positions, as on the hardware, and the curve glides to a new position, so stepping never clicks.
Does it add latency?
A small one: 64 samples at 44.1 to 96 kHz (1.3 ms at 48 kHz) for the oversampling filters, none at 176.4 and 192 kHz. It is always the same and reported to your DAW, which compensates; the host’s bypass is delayed by the same amount. With every gain at 0 and TUBE at 0 % the output is the input, delayed, bit for bit.
What presets does it come with?
42 factory presets in 9 folders: Default, Drums, Bass, Guitars, Keys, Vocals, Mix Bus, Mastering and Creative. Each preset’s OUTPUT was fitted on its folder’s material so it comes out as loud as it went in, within 0.05 dB for all but Telephone, so comparing presets is about tone, not level. TUBE was set for tracks peaking at −8 dBFS and buses at −4: hotter tracks get more colour. AUTO GAIN is off in the presets.