VEIRA Saturator Red

What does VEIRA Saturator Red do?

It adds grit, warmth and edge in the manner of analog circuits, with four modes: OVERDRIVE (the classic overdrive pedal), TRANSISTOR (a single transistor stage), DIODE (hard clipping with two silicon diodes) and FUZZ (the two-transistor fuzz). DRIVE goes up to 36 dB, TONE tilts what goes into the drive, LOW CUT and HIGH CUT shape it, AUTO GAIN keeps the loudness and MIX blends the dry signal in. It is the bold one of the four VEIRA colour saturators.

Which MODE should I choose?

TRANSISTOR for warmth and thickness (the 2nd harmonic first): bass DI, vocals, keys, buses and masters. OVERDRIVE for mids that push forward with tight lows (it drives above about 720 Hz only): guitars, bass growl, organ. DIODE for an edge that stays clean until it clips: snare crack, pick attack, aggressive vocals, parallel clipping. FUZZ for square, buzzy distortion: guitar and synth fuzz, effects. Measured at 12 dB of DRIVE on a 1 kHz sine at −18 dBFS RMS: OVERDRIVE 4.6 %, TRANSISTOR 10.3 %, DIODE 0.40 % and FUZZ 35 % THD.

Why doesn’t it get louder when I turn DRIVE up?

That is AUTO GAIN: it takes back what DRIVE adds in level at once, then matches the output’s loudness to the input’s over the last few seconds, so you hear the colour, not a louder signal. Switch AUTO GAIN off if you want the level to rise, and set the level with OUTPUT.

What does TONE do?

It tilts the signal into the drive around 800 Hz and takes half of it back after the curve. Turned up, the highs are driven harder: a brighter, more biting distortion; turned down, the lows and low mids are: darker and thicker. Because half of it comes back off, it changes the colour of the distortion more than the clean sound.

How do I saturate in parallel?

Lower MIX. The dry signal is delayed by exactly the oversampling’s latency, so it stays in time with the driven one and the blend never combs. The blend can come out up to 3 dB quieter than bypass, because TONE and the cuts shift the driven signal’s phase a little; the factory presets trim this with their OUTPUT, and you can raise OUTPUT until the meter’s Δ INTEGRATED reads about 0.0 LU.

Does it alias?

Very little. The curve runs at eight times the sample rate through steep filters, with antiderivative anti-aliasing. A 5 kHz sine driven 24 dB left aliasing at the measurement’s floor of −94 dBc in OVERDRIVE, TRANSISTOR and DIODE, and −72 dBc in FUZZ. That cleanliness costs more CPU than a simple saturator; OVERDRIVE is the heaviest mode.

Does it add latency?

Yes: 66 samples at every sample rate (1.4 ms at 48 kHz), the oversampling filters, always the same and reported to your DAW, which compensates. Your DAW’s bypass and MIX’s dry signal are delayed by the same amount, and MIX at 0 % is the input, delayed, bit for bit.

My distortion sounds flubby. What can I do?

Too much low end is going into the curve. Raise LOW CUT (60–150 Hz), which works before the drive, or use OVERDRIVE, which drives above about 720 Hz only. If the top fizzes instead, lower HIGH CUT (8–12 kHz), which works after the drive, or turn TONE down.

VEIRA Saturator Red · Help · VEIRA