VEIRA Saturator Gold
What does VEIRA Saturator Gold do?
It is the warm one of the four VEIRA colour saturators, painted brushed champagne gold. VALVE PREAMP is a triode stage led by the 2nd harmonic, TAPE follows magnetic tape’s magnetisation curve with odd harmonics and a soft knee, and TUBE GLOW is a triode whose colour blooms as you play harder. DRIVE (0 to 100 %, up to +36 dB) pushes the band into the curve while AUTO GAIN keeps the level, TONE decides whether the highs or the lows are driven harder, LOW CUT and HIGH CUT choose the band that is driven while the rest passes clean, and MIX blends the dry signal back in time.
Which MODE should I use?
VALVE PREAMP is the default and the all-rounder: the 2nd harmonic leads, the 3rd follows, warm and full at low DRIVE, smoothly and unevenly rounded when pushed; use it on vocals, bass, guitars and keys. TAPE is soft and gluey: mostly odd harmonics, a soft knee that tucks the peaks in and a softer top; use it on drum buses, overheads, backing vocals and the mix bus. TUBE GLOW follows how hard you play: nearly clean on quiet passages and rich on loud ones (a note 24 dB louder gets 30 dB more 2nd harmonic); use it on electric piano, clean guitar and kick. At DRIVE 50 % on a 1 kHz sine at −18 dBFS RMS: VALVE PREAMP 15.7 % THD, TAPE 16.2 %, TUBE GLOW 21.5 %.
What does TONE do?
TONE decides where the colour is made. It tilts what goes into the curve around 800 Hz, up to 6 dB each way, and takes the same tilt back off what the curve adds. Towards + the highs are driven harder, for brighter, edgier harmonics; towards − the lows, for thicker, warmer ones. Half of the tilt (up to 3 dB each way) stays on the saturated band, so the knob is heard on quiet passages too. Measured: +100 % gives a 3 kHz note 7 dB more 3rd harmonic, −100 % a 100 Hz note 8 dB more.
What do LOW CUT and HIGH CUT do?
They choose the band that is driven, at 24 dB per octave: LOW CUT from Off or 20 Hz to 1 kHz, HIGH CUT from 1 to 20 kHz or Off. What they cut is not lost: it passes clean around the drive and is added back. Raise LOW CUT to keep a bass’s sub tight and clean while its mids growl: with LOW CUT at 400 Hz and DRIVE at 100 %, a 50 Hz note passed within 0.01 dB. Lower HIGH CUT to keep a bright top out of the drive, which is also the cure for fizz. With both Off the whole signal is driven.
Why doesn’t it get louder when I turn up DRIVE?
That is AUTO GAIN, on by default: it gives back what the curve takes, so DRIVE changes the colour, not the level. When the plugin starts it measures each curve at every DRIVE step on a 1 kHz sine at −18 dBFS RMS, and that sine keeps its level within 0.02 dB at any DRIVE and MODE. On music it is close but not exact: a rock mix at DRIVE 60 % stayed within 2 dB, so trim OUTPUT until the meter bridge’s Δ INTEGRATED reads about 0.0 LU. Switch AUTO GAIN off and half of DRIVE’s decibels come out as gain, as a real preamp gets louder.
Does it add latency?
Yes: 102 samples at every sample rate (2.1 ms at 48 kHz), from the oversampling filters. Only what the curve changes is made at eight times the sample rate, so the clean part of the signal never passes those filters. The latency never changes and is reported to your DAW, which compensates it; your DAW’s bypass is delayed by the same amount, so a bypassed track stays in time. MIX blends the dry signal delayed to match, so parallel saturation never combs, and at MIX 0 % the output is the input, delayed, bit for bit.
What do TRANSFER and HARMONICS show?
TRANSFER draws the band’s output against its input at your settings, from −1 to +1, computed from the engine’s own curves: VALVE’s curve in VALVE PREAMP, the loop tape draws for a full-scale sine in TAPE (TAPE LOOP), and the quiet and loud curves in TUBE GLOW (QUIET / LOUD); the dashed diagonal is no change, and a dot shows your input’s peak right now. HARMONICS measures what a 1 kHz sine at −18 dBFS RMS gets from a copy of the engine at your settings: the 2nd to 9th harmonics in dB against the note, even ones in a lighter gold, with the THD.
What presets does it come with?
40 factory presets in 9 folders: Default, Drums, Bass, Guitar, Keyboards, Vocals, Mix Bus, Mastering and Creative FX, from Drum Bus Warmth, Bass Valve Grit and Crunch Preamp to Vocal Tape Smooth, Mix Tape Glue, Master Valve Sheen and Telephone Glow. They were made on tracks peaking at −8 dBFS, drums and buses at −4 dBFS and premasters at −3 dBFS; on hotter material the colour is stronger, so lower DRIVE. AUTO GAIN is on in every one, and every preset but Init comes out within 0.05 dB of bypass on the material it was made for.