VEIRA Amp Rig
What does VEIRA Amp Rig do?
It turns a guitar recorded straight in (a DI track) into the sound of a miked amp. It is laid out as a rig: a compressor and an overdrive pedal, an amp with three channels (an American-style CLEAN, a British-style CRUNCH and a modern HIGH GAIN), a cabinet with a microphone you can move, and an EQ, a delay and a reverb after it. A gate, a tuner and meters sit around it.
How do I load it in my DAW?
It is an effect: insert it on the audio track with your guitar, mono or stereo. On a mono track it plays in stereo; a stereo input is summed to mono for the amp, as one amp hears one guitar. In Logic Pro it is under Audio Units ▸ VEIRA ▸ VEIRA Amp Rig, and in VST3 hosts under Fx ▸ Distortion.
How loud should my guitar come in?
Aim for peaks of −12 to −6 dBFS on the IN meter, and set INPUT (±12 dB) to get there. A hotter input drives the amp harder, like a hotter pickup; the GATE threshold then needs to sit just above the noise between notes.
Why does my sound not get louder when I turn up GAIN?
On purpose: 75 % of the change in loudness from GAIN and MASTER is taken back, so the knobs mostly add drive, and the three channels play at the same loudness at their defaults. Set the level you want with OUTPUT; every factory preset plays at −18 LUFS.
How do I move the microphone?
Drag it on the speaker, or in the side view, or turn POSITION and DISTANCE. POSITION goes from the centre of the speaker (brightest) to the edge of the cone (darker and rounder). DISTANCE goes from 1 cm, with the microphone’s proximity bass, to 60 cm, where you hear the other speakers, the floor and a little room.
Can I use my own impulse response?
Yes. Click LOAD IR or drop the file on the speaker: WAV, AIFF or FLAC, up to 2 seconds. It is mixed to mono, its leading silence trimmed, matched to the session’s sample rate and levelled like the built-in cabinets. CLEAR IR goes back to the built-in cabinet.
What happens to my impulse response when I open the session elsewhere?
The session keeps a copy of it, so it plays the same on another computer or after the file is gone. A user preset you save keeps only the file’s path: if the file is missing when you load it, the built-in cabinet plays and the panel shows MISSING.
Can I use it with a real cabinet or another IR loader?
Yes: switch the CABINET off and the amp’s own output goes on to the effects, for a real speaker cabinet or another impulse response loader after it. The pedals, the amp and the effects stay as they are.
Does it add latency?
A little, and always the same: 58 samples at 44.1 and 48 kHz (1.2 ms at 48 kHz), 18 at 88.2 and 96 kHz, from the oversampling. It is shown on the panel and reported to your DAW, which compensates for it; the cabinet adds none. To play through it live, use a small buffer in your DAW.
How do I tune my guitar?
Switch the TUNER on: it shows the note and how many cents sharp or flat you are, and mutes the output while it is on, as a stage tuner does. Switch it off to play again.