VEIRA Mastering EQ

What is VEIRA Mastering EQ for?

VEIRA Mastering EQ is a stepped, two-channel equalizer for the small, broad corrections a finished mix needs at mastering: a little more air, a little less mud, a low end that sits right on every speaker. Every control clicks to a fixed position, so settings can be written down and recalled exactly. It also works on buses and tracks: the factory presets cover drums, bass, guitar, keys, strings, brass, woodwinds, vocals and the mix bus.

Should I use ANALOG or LINEAR?

Both give the same curve. ANALOG has no latency of its own and shifts the phase as an analog desk does; LINEAR has no phase shift at all, at the cost of about 100 ms of latency (106 ms at 44.1 kHz), which your DAW compensates. On a master, use LINEAR whenever you cut the lows or work in M/S: an ANALOG low cut on a dense, limited mix can raise the peaks by a few dB, and LINEAR keeps them where they were. While recording or playing live through the plugin, use ANALOG.

How do I work in mid/side?

Set MODE to M/S and switch LINK off. Channel A now works on the middle (what both speakers share: usually the kick, bass, lead vocal and snare) and channel B on the sides (reverbs, wide guitars and keys, the room). Brighten only the width with a HIGH SHELF on B, or cut the lows of B so the low end is mono: Mid-Side ▸ Mono The Lows does that at 120 Hz. Set PHASE to LINEAR for M/S work on a master. On a mono track there are no sides, so channel A does the work.

Why are channel B’s knobs greyed out?

LINK is on: channel B follows channel A, so one EQ works on both channels and B’s own knobs are dimmed. B keeps its settings for when you switch LINK off. THE CURVE’s legend then reads B RIGHT = A (or B SIDE = A in M/S). The factory presets for tracks and buses are linked, so they work the same on a mono or a stereo track.

How much colour does the tube add?

It depends on TUBE and on the level, as with a real tube. At 30 % a tone at −18 dBFS gets about 0.25 % THD and one at −6 dBFS about 1 %, mostly second harmonic: a touch of density and glue. At 100 % it’s about 7 % at −6 dBFS and 12 % near full scale, drive as an effect. The factory Mastering presets stay at or under 40 %. At 0 %, or with TUBE IN out, the stage is exactly clean. Check the peaks before your limiter: the tube lifts the negative peaks a little.

Why does the 25 kHz HIGH SHELF seem to do so little?

The shelves are broad: a shelf reaches half its gain at its frequency and its full gain about two octaves beyond it. So HIGH SHELF at 25 kHz and +8 dB adds about +3 dB at 20 kHz and +0.6 dB at 10 kHz: an openness you feel more than a boost you hear. THE CURVE shows this honestly. For a lift you clearly hear, use 10 to 16 kHz.

Which preset should I start from?

VEIRA Mastering EQ comes with 82 factory presets in 14 folders: Default (Init), Drums, Bass, Guitar, Keyboards, Strings, Brass, Woodwinds, Vocals and Mix Bus, plus Mastering (17 small, broad moves), Mid-Side (all in LINEAR), Restoration (rumble, 50 and 60 Hz hum, dull or harsh transfers, cassette and vinyl) and Creative FX. Hover over the preset display to read its note, which says what to set first. The Mastering, Mix Bus and Mid-Side presets play within a quarter of a dB of bypass, so you can compare fairly.