VEIRA Vinyl

What does VEIRA Vinyl do?

It puts your music on a record. DUST adds the surface’s soft hiss and fine ticks, and CRACKLE its pops, bursts of crackle and, from 60 %, a scratch that comes back on every turn of the record; each has an AMOUNT (how much) and a VOLUME (how loud). AGE gives the music the band of an old record and cartridge (the lows and the highs rolled off, a little presence, the stereo narrowed), WOW makes the speed waver once a turn, SPEED turns the record at 33 or 45, and HUM adds a turntable’s mains hum at 50 or 60 Hz. OUTPUT sets the level. The 34 factory presets, in 8 folders from Fresh Pressing to Lo-Fi and Texture, are good starting points.

Is VEIRA Vinyl really free?

Yes. On its page, click Get it free: with a VEIRA account and a confirmed email address it goes straight into your account, without a payment or a card. Then VEIRA Manager installs it on up to 3 computers and keeps it up to date, like every VEIRA plugin, and it’s yours to keep. If you have paid plugins in your cart too, VEIRA Vinyl is added to your account on its own and the payment covers only the others.

Why is it silent when my song is stopped?

Because a record only makes noise while it plays. VEIRA Vinyl follows your DAW’s transport: when the song plays, the record turns on screen, the arm goes down and the noise fades in over 60 ms; when you stop, the arm goes back, the platter runs down and the noise fades out over 150 ms, so nothing thumps and a stopped session is silent. AGE and WOW, which change the music itself, keep working while the song is stopped. In the standalone app, with no song, the noise plays all the time.

What’s the difference between AMOUNT and VOLUME?

AMOUNT sets how much dust or crackle there is; VOLUME sets how loud it plays, from −36 to +12 dB. For DUST, AMOUNT sets the number of ticks (from 4 to 164 a second) and how full the hiss is; for CRACKLE, how many pops and bursts (from about one pop every three seconds at 10 % to seven a second at 100 %) and, from 60 %, a scratch on every turn. So a record with a lot of quiet crackle is a high AMOUNT with a low VOLUME, and a few loud pops a low AMOUNT with a high VOLUME. At 0 dB the dust’s hiss sits about 56 dB under full scale at 40 %, and the loudest pops reach about −18 dBFS. At 0 % AMOUNT there is none at all.

What do AGE and WOW do?

AGE plays the music through the band of an old record and cartridge: the lows roll off from 20 Hz up to 140 Hz, the highs from 20 kHz down to 4.5 kHz, a little presence comes up at 1.6 kHz (up to +3 dB) and the stereo narrows, to 40 % of its width at 100 %. WOW makes the record’s speed waver once a turn, with a little flutter on top, up to about ±1 % of pitch at 100 %: a gentle drift at 10 to 20 %, a warped record from 50 %. At 0 % each leaves the music untouched.

Which SPEED and HUM should I choose?

SPEED sets how fast the record turns, 33⅓ or 45 turns a minute, and with it the rate of WOW, of the scratch and of the dust’s swell: a turn every 1.8 seconds at 33, every 1.3 seconds at 45. Choose 45 for a single’s faster movement, 33 for an album. HUM adds a mains hum with its harmonics, low under the music at about −55 dBFS: 50 Hz is the hum of Europe and most of the world, 60 Hz of the Americas. Leave it OFF for a clean deck, or use it for an old setup with a bad ground (the Hum & Faults presets).

Does it add latency?

A little, always the same: 3.5 ms (168 samples at 48 kHz), the delay WOW needs to move the music in time. It is reported to your DAW, which compensates for it, and it stays the same at every setting, even with WOW at 0 %, so turning a knob never shifts your track. Bypassed, the plugin keeps the same delay, so the track stays in time. With DUST and CRACKLE at 0 %, AGE and WOW at 0 % and HUM off, the output is the input, delayed by the latency, bit for bit.

VEIRA Vinyl · Help · VEIRA