VEIRA Woodwinds
What is VEIRA Woodwinds?
A woodwind section you play from a keyboard: flute, oboe, clarinet and bassoon, and the ensemble, the wind choir across the keyboard. Play one player (SOLO), two (PAIR) or a full section (SECTION: six flutes, four oboes, six clarinets, four bassoons). Put it on an instrument track: it takes MIDI and has no audio input.
Is it sampled?
No. Every sound is a physical model computed in the plugin: for every player, the reed or the air jet, the instrument’s bore with its holes and bell, and the hall, sample by sample, at about 96 kHz. There are no recordings inside. That is why a swell sounds like players blowing harder and brighter, and why two players on one note are two instruments.
How do I play the dynamics?
With the mod wheel (CC 1), or a breath controller (CC 2) with DYNAMICS FROM set to BREATH: once moved, it plays the dynamics continuously, so swells are played rather than drawn. Until then the DYNAMICS knob sets them; turning the knob gives it back the lead. Or choose VELOCITY, and each note’s velocity sets its dynamic. STACCATO always takes its dynamic from the velocity.
Why do my notes slur?
Because wind players slur: a note played while another is held changes the fingering without a new tongue, with GLIDE setting how long the change takes. Lift each key before the next to tongue every note. In SOLO on an instrument it is one line, as a wind player plays one note at a time; use PAIR or SECTION to divide a chord.
How does a section share the notes?
Every player plays one line. The notes held are shared out from the top down: one note is played in unison by all the players, two notes are divided, more notes than players get one player each. In the ensemble, each note goes to the sections that have it in their register: E2 is the bassoons alone, G#3 bassoons and clarinets, G#4 clarinets and oboes, C6 the flutes alone.
How do the articulations and keyswitches work?
Choose SUSTAIN, STACCATO, FLUTTER or TRILL with the buttons, or with the keyswitches C0, C#0, D0 and D#0 (MIDI notes 12 to 15, with C4 as middle C; some hosts name them C-1 to D#-1). The keyswitches make no sound: press one, then play, and the notes that follow use it until you choose another.
Why do the ranges stop where they do?
Each instrument plays its usual range: the flute C4 to C7, the oboe A#3 to D6, the clarinet D3 to G6 (as it sounds) and the bassoon A#1 to A#4. At the top they stop a little short of what the real instruments can reach, where the model no longer speaks reliably at every dynamic. The keyboard strip shows each range.
Is it in tune, and can it clip?
Each player listens to the note it plays and corrects it, so every note is within a cent at every dynamic and sample rate. There is no latency. After VOLUME, a stereo-linked limiter at −1.5 dBFS with a soft curve above it keeps even ten fortissimo notes on the full sections at VOLUME +6 dB under full scale.
What presets does it come with?
40 factory presets in seven folders: Default, Solo, Sections, Ensemble, Short, Cinematic and Pop & Ballad, from Solo Flute, Pastoral Oboe and Smoky Clarinet to Wind Choir, Wind Quartet, Staccato Winds, Flutter Flutes and Ballad Flute. Each was levelled on the same phrase in its own register to about −18 LUFS; most short ones sit a little lower.