VEIRA Multiband Red

What does VEIRA Multiband Red do?

It splits your sound into four bands with three crossovers you drag on the display, and compresses each band with its own fast FET-style compressor: THRESHOLD, RATIO, ATTACK, RELEASE and MAKEUP or AUTO, plus SOLO, BYPASS and STEREO, MID or SIDE per band. It is the punchy one of the four VEIRA colour multiband compressors, painted deep lacquered red.

Should I use LINEAR PHASE?

Use the default (zero latency) for tracking, playing live and single tracks. Use LINEAR PHASE on mix buses and masters, above all on material that is already limited: the zero-latency crossovers turn the phase near each crossover, which can raise peaks (a pop mix peaking at −4 dBFS reached +1.8 dBFS through a Mix Bus preset in zero latency). LINEAR PHASE adds 24 ms at 44.1 or 48 kHz (1152 samples), reported to your DAW, and the peaks stay at the input’s. The Mix Bus and Mastering presets use it.

How do I move the crossovers?

Drag the round handles at the foot of the dashed lines on the BANDS display. Crossover 1 runs from 30 Hz to 1 kHz, 2 from 100 Hz to 5 kHz and 3 from 1 to 16 kHz; they stay at least 1.25 × apart. Double-click a handle to put it back (120 Hz, 800 Hz and 5 kHz by default). Each crossover is also a host parameter you can automate.

What does AUTO do?

AUTO gives back the band’s average reduction, measured over about 3 seconds while the band sounds within 30 dB of its threshold, so the band keeps its average level while its peaks are held, and the tonal balance doesn’t drift as you set thresholds. MAKEUP is dimmed while AUTO is on; switch AUTO off to set the band’s gain yourself.

How do I use EXT KEY?

Route a track (a kick, a voice-over) to VEIRA Multiband Red’s sidechain input in your DAW, then switch EXT KEY on. Each band then listens to the same band of the key: a kick can duck only the low band of a bass (18 dB in our test) while its other bands don’t move. EXT KEY is dimmed while no sidechain is connected. The Sidechain presets duck on purpose and are not level-matched.

What do STEREO, MID and SIDE do?

They choose which part of a band is detected and changed. STEREO: both sides together, by the louder one. MID: only the centre of the band; the sides pass untouched. SIDE: only the sides; the centre passes untouched. For example MID in the low bands holds the kick and bass without touching the width, and SIDE in the top bands calms a bright, wide chorus without dulling the vocal.

Will a fast attack distort my bass?

Each band holds its level for a little more than half a cycle of its lowest frequency, so a fast attack doesn’t ride the bass wave: 45 Hz compressed 9 dB at a 0.1 ms attack stayed under 0.5 % THD. A very short RELEASE with a lot of reduction can still move the gain quickly on low notes; raise band 1’s RELEASE a little if you hear grit.

Why does SOLO not show up in my bounce?

SOLO is a listening aid: it lets you hear one or more bands alone while you set the crossovers. Offline bounces always leave it out, so a bounce never comes out as a single band by mistake.

VEIRA Multiband Red · Help · VEIRA