VEIRA Bass Enhancer Blue
What does VEIRA Bass Enhancer Blue do?
It is the console one of the four VEIRA colour bass enhancers, painted 1970s steel blue, and it does two jobs for the low end. A compressor that works on 80 Hz and below only evens out the deepest notes with the smooth timing of a console bus VCA (3:1, an 8 dB soft knee, 20 ms in and 180 ms out), and gives back on average what it takes, so the low end is evened out, not thinned. One big ENHANCE knob adds the 2nd to 6th harmonics of the lows, as a console’s output transformer makes them when the bass drives its iron, so the bass line is heard on phones, laptops and earbuds. There are four controls: THRESHOLD, ENHANCE, OUTPUT and LISTEN, and no latency.
How do I set THRESHOLD?
THRESHOLD is a fader, and the lows’ live level (80 Hz and below, RMS) runs in its track as a bar: blue up to the handle and red where it goes past it, with a thin mark that holds the peak for 1.5 seconds. Pull the handle left until the loudest low notes turn the bar red, and watch GAIN REDUCTION: 2 to 4 dB gives a firmer, steadier sub; 4 to 6 dB holds the lowest notes close together, the usual setting on bass, 808 and kick. Fully right is OFF: the compressor is out and only ENHANCE works. Double-click the fader for its default, −20 dBFS, or right-click it and type a value (or “off”).
Why doesn’t the compressor make the low end quieter?
Because it gives back what it takes. It keeps track of the energy it took from the lows over about the last 3 seconds and gives that back (up to 12 dB), so the loud notes come down, the quiet ones come up and the usual level of the lows stays where it was: bass notes 12 dB apart came out 7.7 dB closer while the lows’ energy moved 0.06 dB. GAIN REDUCTION and the red reduction on the LOW END display show how hard the loud notes are held, before that average is given back, so they can read more than the net change. To make the low end plainly quieter, use an EQ’s low shelf after it.
How much ENHANCE should I use?
ENHANCE drives the iron harder and mixes more of its harmonics in. 10 to 25 % adds weight and definition you hardly hear on big speakers but that makes the bass line appear on small ones; most mix bus and mastering presets sit there. 25 to 55 % gives a clear, present bass on any speaker, the usual range for bass, 808 and kick. 60 to 80 % makes the harmonics part of the sound, as the Small Speakers presets do, and at 100 % they come within about 3 dB of the note. On a 55 Hz note the harmonics sit 17 dB under it at 20 %, 9 dB at 50 % and 3 dB at 100 %. Check on earbuds or a phone, and watch the output at high settings: a 50 Hz note’s peak rose 2.0 dB at 100 %.
Does it thin the bass or change the note?
No. ENHANCE adds only harmonics, each at its natural phase against the note, exactly where the transformer’s curve would put it; the note itself is never added again, so it can’t cancel: it moves by less than 0.05 dB at any setting. The compressor works through a 4th-order low shelf at 80 Hz instead of splitting the signal into bands, so there is nothing to add back wrong, and nothing above the lows moves: with 10 dB of gain change, 120 Hz moves 0.45 dB and 240 Hz and up under 0.005 dB. A steady 1 kHz tone over a compressed bass changed by 0.0000 dB.
What does LISTEN do, and why does my bounce sound different?
LISTEN is a listening aid: it plays only what the plugin works on, the lows (100 Hz and below) and the harmonics ENHANCE adds, so you can hear what the compressor holds and what the harmonics sound like on their own. Offline bounces always leave it out, so a bounce never comes out as lows only by mistake. If LISTEN was on while you listened, you heard only the lows and the harmonics; switch it off to hear the whole sound.
Does it add latency, and does it change my sound when it has nothing to do?
There is no latency, so it is fine while you record and play. With THRESHOLD at OFF, ENHANCE at 0 %, LISTEN off and OUTPUT at 0 dB, the output is the input, bit for bit, even after the compressor and ENHANCE have worked and let go. It works in mono and stereo; in stereo both channels share one gain, so the image doesn’t move.
What presets does it come with?
22 factory presets in 6 folders: Default, Drums, Bass, Mix Bus, Mastering and Small Speakers, from Kick Weight, Tight Kick Lows, DI Bass Iron and Bass Growl to Bus Low Glue, Subtle Console Iron, Phone Bass and Earbud 808. They were made on drums at −4 dBFS peak, bass tracks and 808s at −8, mix buses at −4 and masters at −3 dBFS, so on a different level set THRESHOLD first. Every preset but Init was level-matched to bypass within 0.05 LU, and on a phone-sized speaker the Small Speakers presets add 11 to 13 dB to what it plays of the bass. You can save your own with SAVE.