VEIRA Bass DI Enhancer
What is VEIRA Bass DI Enhancer for?
It finishes a bass recorded through a DI box: it evens out the low notes, adds harmonics so the line is heard on phones and laptops, and shapes the tone by taking out rumble and mud and bringing up weight, growl and string. All three processors (low-end compression, saturation and EQ) move together on one knob, ENHANCE. It works on any single bass: an electric bass through a DI, a synth bass, a bass amp's microphone or an upright's pickup.
What's a good first setting?
A fresh instance (Default ▸ Init) is WARM at ENHANCE 50 %. Start at 0 %, play the busiest part of the song in the mix, and turn up until the bass sits steadily and you can follow the line on small speakers, then go back a little; around 30 to 60 % is a typical setting. Or load a preset for how the bass is played (Finger, Pick, Slap, Synth Bass, Jazz & Upright) or for the style of music; each preset's note says which control to move first.
Which STYLE should I choose: CLEAN, WARM or GRIT?
CLEAN is a modern, hi-fi bass with the most compression and only a touch of harmonics, and it doesn't cut the top. WARM, the default, is round and vintage, with the most weight and tube-like harmonics. GRIT drives only what is above 220 Hz, so it growls and cuts through while the low end stays clean; it suits rock and metal and making a bass heard on small speakers.
How do I read the LOW-END COMP needle?
It shows how much the compressor is taking off the low end right now, from 0 dB at the right to 18 dB at the left. At a moderate setting it should swing a few dB with the loudest notes and come back between them. A needle at rest doesn't mean the plugin is idle, because makeup gain is lifting the quiet notes, and after you start playback it takes about a second and a half to learn the bass's level.
What does the DRIVE meter show?
It's a column of twelve lamps showing how hard the saturation works, from −60 dB at the bottom to −4 dB at the top, compared with the bass. As a guide, −60 to −40 dB is a touch, −20 dB is clearly warm and −10 dB is driven.
I turn ENHANCE and hardly hear a difference. Is it working?
Yes: AUTO GAIN is always on and keeps the loudness about where it was, so the change is in the tone, not the level. Listen to how even the low notes are and to the bass on small speakers, and compare with bypass. CLEAN is the subtlest style; its useful range is about 40 to 80 %.
Can I play through it while recording? Does it work in mono?
Yes. The latency is only 64 samples at 44.1 to 96 kHz (1.3 ms at 48 kHz), and none at 176.4 and 192 kHz, which is small enough to play through, and your DAW compensates for it on playback. It works on mono and stereo tracks; in stereo the compressor is linked.
GRIT makes my bass thinner, or the sound is woolly. What should I do?
GRIT reacts to how bright the bass is, so on a pick or slap tone or a synth lower ENHANCE to 25 to 45 %, blend with MIX, or try CLEAN or WARM. If it sounds woolly or too dark, remember WARM and GRIT soften the top more as ENHANCE rises: lower ENHANCE, or switch to CLEAN, which doesn't cut the top.
Why does the first note after a pause come through a little loud?
The compressor has no lookahead, so a note's first few milliseconds pass at the gain the lows had just before it, and after a quiet passage that gain is higher. Lower ENHANCE, or blend with MIX.