VEIRA 6-Band Stereo Imager

What is VEIRA 6-Band Stereo Imager for?

It controls the stereo picture of a track, a bus or a whole mix, one frequency range at a time. Six bands each have their own WIDTH, STEREOIZE, PAN and ROTATE, so you can keep the kick and bass in a solid centre, spread the cymbals and the air, and steer a lopsided part back into place. The STEREO FIELD display shows where every frequency sits between left and right.

Where should I start?

It comes with 74 factory presets in 13 folders, including Mix Bus, Mastering and Mono Fix. After loading one, drag the band splits to where your material’s parts sit, fine-tune each band’s WIDTH, and check with MONO. Every factory preset’s note says which split to move first, and no preset turns on SOLO or MONO.

How do I keep the low end of my mix mono?

Switch on BASS MONO: everything below the BELOW frequency (20 to 500 Hz, default 120 Hz) becomes mono, whatever the bands do. Set it just above the fundamentals of your kick and bass, usually 80–120 Hz, or up to about 150 Hz for vinyl. You can also drag the BASS MONO edge on the STEREO FIELD; double-click it for 120 Hz.

WIDTH does nothing on my track. Why?

WIDTH can only scale side that is already there, so on mono material (or a band that is nearly mono) it has nothing to work on; on the STEREO FIELD its colour stays on C. Use STEREOIZE instead, which creates width for mono and narrow parts. On a mono track, check that the plugin is inserted as mono-to-stereo.

What’s the difference between WIDTH and STEREOIZE?

WIDTH scales a band’s existing side signal, from 0 % (mono) through 100 % (unchanged) to 200 %. STEREOIZE creates width from the band’s mid for mono and narrow parts, without delays, so it never goes out of phase and fades out under about 150 Hz. Neither changes the mono sum; on stereo recordings, reach for WIDTH first.

What does the red area beyond L and R on the STEREO FIELD mean?

Those frequencies are out of phase between the channels and will get quieter or cancel in mono. A little, briefly, is normal on wide reverbs; a lot, or in the lows, is a phase problem. Try BASS MONO or the Mono Fix presets, such as Out Of Phase Pull-In or Haas Width Tamer.

What are the SOLO and MONO buttons for, and why does my bounce sound different?

SOLO plays only the soloed bands, and MONO sums the output to mono so you can hear how your mix folds down. Both are listening aids and are left out of offline bounces and AudioSuite, so a bounce always contains the full stereo output. MUTE is part of the sound and is bounced.

Does the imager add latency?

Yes: the linear-phase band splits need about 24 ms (1152 samples at 44.1 and 48 kHz), constant and reported to your DAW, which compensates on playback. While recording or monitoring live you hear the delay, so insert it after recording or bypass it while tracking; its bypass keeps the same delay, so the track stays in time.

Can I use it on a mono track?

Yes. It accepts a mono input with a stereo output: insert it as a mono-to-stereo plugin (in Logic Pro, the Mono → Stereo version) and use STEREOIZE to create the width from 150 Hz up. The Mono … Spread presets in each instrument folder, such as Guitar ▸ Mono Guitar Spread, are made for this.

VEIRA 6-Band Stereo Imager · Help · VEIRA