VEIRA Echo

What is VEIRA Echo for?

VEIRA Echo is a stereo delay for everything from a short slapback on a vocal to a dub spiral that feeds back on itself. Its repeats land exactly on the beat, and you can place them in the stereo field, give them a rhythm, darken and dirty them on every pass, shift their pitch or play them backwards.

Which preset should I start from?

VEIRA Echo comes with 77 factory presets in 14 folders, sorted by job (Vocals, Guitar, Drums, Sends, Rhythmic, Creative FX and more). Load one close to what you need and hover over the preset display to read its note, which tells you what to adjust first. Default ▸ Init gives you a fresh instance with every control at its default.

Should I use VEIRA Echo on an insert or on a send?

Both work, and only MIX changes. On an insert, start with MIX around 15–30 %; on an aux (send) track, set MIX to 100 % so it returns only the repeats, or load a preset from the Sends folder, which are all at MIX 100 %. If the echo is too loud on an aux, lower the aux fader or the sends rather than MIX.

The repeats aren’t in time with my song. What’s wrong?

Check that SYNC is on, because pressing TAP switches it off. The line under the time menus shows the tempo VEIRA Echo is using (for example AT 120 BPM); if it doesn’t match your song, check your DAW’s tempo. If the host sends no tempo, VEIRA Echo uses 120 BPM.

How high can FEEDBACK go, and will it overload?

FEEDBACK runs from 0 to 110 %. Over 100 % each repeat is louder than the last, so the echo builds up on its own for self-oscillating dub sounds, but a ceiling after the loop keeps the repeats from ever passing 0 dBFS. Bring FEEDBACK back under 100 % and the echo fades away again.

What do DUCK and FREEZE do?

DUCK turns the repeats down while you play, by up to 30 dB at 100 %, and lets them bloom back in the gaps; 40–70 % suits most vocals and lead parts, and it works the same at any track level. FREEZE holds the repeats as a loop for as long as it’s on: nothing new enters and nothing fades, and the ECHO display shows FROZEN with the bars in icy blue.

How do I read and use the ECHO display?

It draws every repeat of a single hit as a bar, left side above the centre line and right side below, placed where it lands in time and as tall as it is loud (full height is 0 dB, the centre line −48 dB). Drag the diamond left and right to set TIME, drag the round handle up and down to set FEEDBACK (up to 100 %; use the knob for more), and double-click a handle to reset it. Hover over a repeat to read its number, time, level and side.

Does VEIRA Echo add latency, and does it work on mono tracks?

There is no latency: the dry signal is never delayed, and at MIX 0 % the output is your input, bit for bit. It runs in mono, stereo, and mono in / stereo out; on a mono-in / stereo-out track the repeats can spread and bounce across the speakers, while on a mono-only track the left and right repeats are summed.

I can’t hear any echo, or the echo never stops. What should I check?

For no echo, check MIX (0 % is dry only), DUCK (at a high setting the repeats hide while you play), HIGH CUT and LOW CUT (close together they leave very little) and FREEZE. If the echo goes on forever, FEEDBACK is at or over 100 % or FREEZE is on; also check for an LFO or the envelope aimed at Feedback, which can add up to ±50 %.

VEIRA Echo · Help · VEIRA