VEIRA Multiband Compressor
What is VEIRA Multiband Compressor for?
It splits your sound into six frequency bands and evens out each one on its own, so a booming low note, a harsh vocal peak or a splashy cymbal can be held in place without touching the rest of the spectrum. It works on single tracks, buses and the master.
How do I get started?
Load the factory preset closest to your job (there are 75 in 13 folders), for example Vocals ▸ Vocal Harsh Tamer or Mix Bus ▸ Mix Glue Gentle, and hover over its name to read what to adjust first. Every band works against its own level, so a preset does the same on a quiet track as on a loud one. Keep AUTO MAKEUP on and set OUTPUT last, so the Δ INTEGRATED reading is near 0.0 LU when you compare with bypass.
Where is the threshold? What does AMOUNT do?
There is no threshold to set: each band measures its own long-term level and AMOUNT (0 to 100 %, default 25 %) decides how firmly it is evened out around it. 15–30 % is gentle glue, 40–60 % is firm control for a problem band, and 70 % and up is a strong effect, a hard hold or the setting for ducking with KEY.
What is the difference between Down, Up and Both in MODE?
Down is a normal compressor that turns a band’s loud moments down, for boom, harshness, sibilance and glue. Up lifts the quiet moments (room sound, ghost notes, sustain) without touching the peaks, and never raises silence or noise more than 40–50 dB below the band’s level. Both pulls the band towards its own level from above and below.
How do I read the BANDS display?
The bright solid line is what the compressor is doing right now and the dashed line is where each band sits on average. Where the solid line drops below the dashed one the band is being turned down, and where it rises above it the band is being lifted. If a band is shaded all the time, its AMOUNT is higher than the job needs.
How do I move the crossovers?
Drag the round handles at the bottom of the BANDS display left or right, and double-click a handle to put that crossover back to its default (80 Hz, 250 Hz, 800 Hz, 2.5 kHz and 8 kHz). Put a crossover just outside the problem, and use SOLO on the band to hear exactly what’s in it while you drag.
Does it add latency, and when should I use LINEAR PHASE?
By default there is no latency at all, so you can use it while recording. LINEAR PHASE gives phase-true bands for mastering and adds 1152 samples (24 ms) at 44.1 and 48 kHz, which your DAW compensates; switch it while playback is stopped, because switching leaves a short gap and it can’t be automated.
Why does a preset seem to do nothing for the first second?
That’s by design: each band learns its own level when it first hears sound and fades AMOUNT in over about 1.5 seconds, so it can’t pump on a wrong first guess. Judge a setting after a couple of seconds of playback.
Why does a KEY or SIDE band do nothing, or my export sound different?
A KEY band with no sidechain connected hears silence and doesn’t move, so check your DAW’s sidechain routing. A SIDE band has nothing to work on with a mono track or identical left and right channels; use STEREO or MID instead. If an export sounds different, look for a forgotten SOLO, which is ignored in offline bounces on purpose.