VEIRA Bass Enhancer White
What does VEIRA Bass Enhancer White do?
It does two jobs for the low end of a bass, a kick, an 808, a drum bus, a mix or a master. A compressor that works on 80 Hz and below only evens the lows out: loud low notes come down and a usual note is given back what it loses, so the low end gets steady without getting quieter. And one big ENHANCE knob adds the exact 2nd to 5th harmonics of those lows, so the bass line is heard on phones, laptops and earbuds that can’t play it. It is the clean one of the VEIRA colour bass enhancers, on a light face with dark screens.
How do I set THRESHOLD?
Watch the bar beside the THRESHOLD fader: it is the lows’ own level, the level of everything at 80 Hz and below, and it lights red where it is over the threshold. Pull the fader down until the loudest low notes light it red and GAIN REDUCTION shows a few dB on them; 6 to 10 dB holds the low notes at one level. The top of the fader is OFF, and the default is −18.0 dBFS. The ratio (4:1 with a 6 dB soft knee) and the timing (25 ms down, 100 ms back) are fixed and set for the lows, so THRESHOLD is the only thing to set. On a quieter or louder track, move it by the difference.
Why doesn’t the low end get quieter when it compresses?
Because it gives back what a note at the lows’ usual level loses (their level over about the last 2.5 seconds), at most 12 dB. Notes louder than usual come out lower and notes quieter than usual come out higher, so the low end evens out while its average stays where it was: a bass line’s average stayed within 0.3 dB at THRESHOLD −30 dBFS. The makeup fades out 40 to 50 dB under the usual level, so silence and tails aren’t lifted, and it waits until it knows that level, so the first note after loading isn’t lifted.
What does ENHANCE add, exactly?
The 2nd, 3rd, 4th and 5th harmonics of the lows, in the proportions 1, 0.75, 0.5 and 0.35, built exactly from each note at its own level and pitch. At 100 % they are together as loud as the lows, at 50 % exactly 6 dB quieter, and at 0 % none are added. The note itself is never added again, so notes from 28 to 95 Hz keep their level within 0.07 dB; the amount doesn’t depend on how loud the track is; each harmonic sits at a fixed phase against the note, so a note’s peak rises at most 0.2 dB at 25 % and 3.4 dB at 100 %; a 60 Hz high-pass keeps them from adding new sub; and nothing aliases.
Does it change anything above 80 Hz?
The compressor hardly does: its gain is applied by a 4th-order low shelf on the whole signal rather than by splitting off a band and adding it back, so nothing can add up wrong where bands meet. With 12 dB of change, 30 Hz moves 12.0 dB, 80 Hz 8.7 dB, 160 Hz 0.19 dB, and nothing moves from 320 Hz up; at no change it is an exact identity. ENHANCE does add sound above 80 Hz on purpose: the harmonics of notes under 80 Hz land in the low mids, which is where small speakers can play them. Lower ENHANCE if that range gets crowded.
What does LISTEN do?
LISTEN plays only what the plugin works on: the lows at 80 Hz and below, after the compressor, and the harmonics ENHANCE adds. Use it to hear what the compressor holds and what the harmonics sound like on their own, then switch it off. It crossfades in and out, so it never clicks, and offline bounces always leave it out, so a bounce never comes out as lows only by mistake.
Does it add latency?
No. It works without latency, so it is fine while you record and play live, and your DAW’s bypass needs no compensation. With THRESHOLD at OFF and ENHANCE at 0 %, the output is the input, bit for bit, even after the compressor and ENHANCE have worked and let go.
What presets does it come with?
22 factory presets in 6 folders: Default, Drums, Bass, Mix Bus, Mastering and Small Speakers, from Kick Sub Control, Bass Even Notes and Mix Low End Glue to Master Translation, Phone Bass and Sub Drop Translator. Every preset was measured through the plugin and comes out within 0.15 dB of bypass loudness (K-weighted), with its peaks at or under −0.7 dBFS, and the Small Speakers presets played the sub line 9 to 12 dB louder on a phone-sized speaker. They were made on tracks peaking at −8 dBFS (drums and sub lines −6, the mix bus −4, masters −3); THRESHOLD works against the lows’ own level, so on a different track move it first.