VEIRA Comp

What is VEIRA Comp for?

VEIRA Comp is a feed-forward, stereo-linked compressor for everything from a single vocal to the master bus. It evens out loud and quiet moments, and it adds parallel compression (MIX), tube-style warmth (TUBE) and sidechain ducking (EXT SIDECHAIN), with displays that show what every move does to your signal.

Which preset should I start from?

VEIRA Comp comes with 72 factory presets in 13 folders, such as Drums, Vocals, Mix Bus, Mastering and Sidechain. Load the one closest to your job, then hover over the preset name to read its note on what to adjust first. Default ▸ Init gives you a fresh instance with every control at its default.

A preset compresses far too much (or too little) on my track. What should I change first?

The presets assume healthy levels: single tracks peaking around −10 to −6 dBFS, close drum mics at −6 to −3 dBFS, and buses and the master at −6 to −3 dBFS. If your track is hotter or quieter, move THRESHOLD by the same number of dB first and leave the other controls alone.

How much gain reduction should I aim for?

As a starting point: 2–4 dB for gentle levelling and the mix bus, 4–8 dB for firm vocal and bass control, and 10 dB or more as an effect or for parallel compression. On the mix bus, 1–3 dB is usually plenty; if you can hear it working, back off.

Why do the gain-reduction bar and its number show different values?

They measure differently on purpose. The number beside the gain-reduction meter shows the deepest gain reduction of the last quarter-second (250 ms), while the bar moves like the needle of a real VU meter and averages, so it sits lower.

What does MIX do?

MIX (0 to 100 %, default 100 %) blends the compressed signal with the untouched dry signal, which is parallel or “New York” compression. The dry signal is delayed by exactly the same amount as the compressed one, so blending never causes phasing; for parallel drums, settings around 25–45 % are typical.

Does TUBE make the track louder?

No. TUBE adds mostly second-harmonic warmth but its small-signal gain is exactly unity, so switching it on and off compares colour, not loudness. On loud material the added harmonics can add a fraction of a dB of measured loudness, so check the Δ reading.

How do I use the sidechain, and why does EXT SIDECHAIN do nothing?

Route the key track (for example the kick) to VEIRA Comp’s sidechain input in your DAW, then switch on EXT SIDECHAIN; the status line under it should read “Key: the sidechain input”. If it reads “Key: no sidechain connected”, your DAW hasn’t connected the input yet, and if it reads “Key: the sidechain input” but the gain-reduction meter doesn’t move, the key may be too quiet for the threshold, so lower THRESHOLD.

Why did my track get quieter after compressing, and does VEIRA Comp add latency?

Getting quieter is normal, because compression turns peaks down: raise OUTPUT until the Δ INTEGRATED reading on the meter bridge is about 0.0 LU, then compare with bypass. Latency is a constant 49 samples, reported to your DAW for delay compensation, and it stays the same whether TUBE is on or off.

Can I type a value, or make the window bigger?

Yes. Right-click a knob (Control-click on a Mac), type the value and press Return; double-click a knob to return it to its default. To resize the window, drag its bottom-right corner: it scales from 75 % to 200 %, keeps its proportions, and the size is saved with your session.

VEIRA Comp · Help · VEIRA