VEIRA Tape Delay

What is VEIRA Tape Delay for?

VEIRA Tape Delay is a tape echo machine for anything from a fifties slapback on a guitar or a voice to long dub trails and self-oscillating sirens. Every repeat is recorded onto the tape again, so the echoes saturate, darken and round off as they fade, and sit behind the dry sound instead of competing with it. It has no latency, so you can also use it while you record.

What’s the difference between MULTI-HEAD and SINGLE HEAD?

MULTI-HEAD is the classic studio echo: three playback heads at one, two and three times TIME (HEAD SELECT chooses which play), on a slower, darker tape, and TIME is the motor’s speed, so the echoes bend in pitch when you change it. SINGLE HEAD is one playback head that slides to TIME on a tape twice as fast: brighter, cleaner repeats with less wow, the sound for slapback. In SINGLE HEAD, HEAD SELECT has no effect.

Why does the pitch of the echoes bend when I change TIME?

In MULTI-HEAD, TIME is the speed of the tape’s motor, and the motor takes about a second to settle. While it changes, the echoes already on the tape play back at a different speed from the one they were recorded at, so they bend down while the tape slows and up while it speeds up, as on a real machine. Tempo changes with SYNC on do the same. If you don’t want it, change TIME between phrases, or use SINGLE HEAD, which moves its head instead.

How do I put the echoes in time with my song?

Switch SYNC on and choose a NOTE: it sets the first head’s echo as a note value of your DAW’s tempo, from 1/64 to a whole note with dotted and triplet values. Heads 2 and 3 come at twice and three times it, so NOTE 1/16 with HEAD SELECT on 1+2+3 gives echoes on the 1/16, the 1/8 and the dotted 1/8. The echo time stays within TIME’s range of 20 ms to 1 s, so at slow tempos the longest note values are held at 1 s.

The echoes keep growing and won’t stop. What’s wrong?

INTENSITY is above about 100 %, so the loop is self-oscillating: each repeat comes back louder until the tape’s saturation holds it, and the echoes never pass −1 dBFS. Turn INTENSITY below 100 % and they die away. It’s a sound in its own right: the presets Dub Siren Runaway, Self Oscillation Drone and Infinite Hold Loop start there, and you can sweep TIME while it runs for a siren.

Should I use VEIRA Tape Delay on an insert or on a send?

Both work. On an insert, MIX sets how much echo you hear: 15 to 35 % is typical, and the dry signal passes untouched. On an aux (send) track, set MIX to 100 % so it returns only the echoes, or load a preset from the Sends folder, which are all at MIX 100 %; then set each track’s send. For dub throws, automate a send up on the hit you want to echo.

Which preset should I start from?

VEIRA Tape Delay comes with 74 factory presets in 14 folders: Default (Init), Drums, Bass, Guitar, Keyboards, Strings, Brass, Woodwinds, Vocals and Mix Bus, plus Sends (MIX 100 % for an aux), Rhythmic (the head combinations with SYNC), Dub and Creative FX. Start from your instrument’s folder and hover over the preset display to read its note, which says what to set first. The insert presets come out within half a dB of bypass.