VEIRA Guitar DI Enhancer

What does VEIRA Guitar DI Enhancer do?

It makes an acoustic guitar recorded straight from its pickup (an under-saddle piezo, a soundhole pickup, the DI out of an acoustic preamp) sound like the guitar, with one knob. ENHANCE moves three things together, in proportion: an EQ that gives the body back around 130 to 160 Hz, takes the boxiness out around 300 Hz and the piezo quack out around 2 to 2.5 kHz, softens the string zing and adds air on top; a gentle compressor that evens the strums and the picking; and VEIRA Space’s reverb, which puts the guitar in a room. AUTO GAIN keeps the loudness about where it was, so what you hear changing is the tone. STYLE picks NATURAL, WARM or BRIGHT, MIX blends it with the dry pickup and OUTPUT sets the level. There is no latency.

How is it different from VEIRA Bass DI Enhancer?

They are built the same way, one knob for a whole chain, with AUTO GAIN and a STYLE switch, but for different instruments. The bass version moves low-end compression, saturation and a bass EQ, because a DI bass needs harmonics to be heard on small speakers and an even low end. The guitar version moves a pickup EQ, a full-band leveller and a reverb, because an acoustic pickup needs its body back, the quack out and a place around it rather than harmonics. The guitar version also has no latency at all (the bass version has 64 samples from its oversampling), and its three styles each bring a different room: a small room, an echo chamber or a plate.

Which STYLE should I use?

NATURAL is the guitar as it sounds in the room and the all-round choice: a singer-songwriter’s guitar, folk, a stage tone, fingerstyle. WARM is rounder and fuller, with the most body, the quack and the zing taken further down, the top shelved down from 9 kHz and a warm chamber: for ballads, for a thin pickup that needs its body back, and when a bright pickup gets tiring. BRIGHT is sparkle: the boxiness out, plenty of air from 9 kHz, the lightest levelling and a plate: for pop strumming that has to cut through a dense mix, a flatpicked lead line or a dull soundhole pickup. On a thin or harsh pickup keep BRIGHT moderate, or use WARM. You can switch while the guitar plays: the EQ and the levelling crossfade over 40 ms and the reverb hands over without a click.

Where should I set ENHANCE, and why does the level hardly change?

Start at 0 %, play the busiest part of the song in the mix, and turn up until the pickup stops sounding plugged in and the strums and the picking sit at one level; 40 to 65 % is typical, and then go back a little. The level hardly changes because AUTO GAIN is always on: it takes back what the EQ and the reverb add or take away in loudness, measured within 1.2 dB from 25 to 100 % on all three styles, so you can’t be fooled into thinking louder is better. Listen to the quack between 2 and 3 kHz, to the evenness of the strums and to the space around the guitar, and compare with bypass: the meter bridge’s Δ reading tells you the levels match. Below about 40 % the room is only a short ambience; it becomes clearly audible from about 70 %.

I want the tone but less reverb, or more reverb than tone.

ENHANCE sets the room together with everything else, but MIX and the styles give you room to move. For the same tone with less room, lower MIX a little (the preset Stage Dry Control does this, at MIX 70 %, for a venue or a mix that has its own reverb), or switch to BRIGHT, whose plate is blended in least. For more room than tone, raise ENHANCE and lower MIX: Room Only is NATURAL at 100 % with MIX at 35 %, mostly the dry pickup with the room blended in, and MIX is the room’s amount. The SPACE meter shows how much room is in the sound: around −30 dB is a hint you feel more than hear, −20 dB a clear space, −12 dB a lot.

Can I record and play live through it?

Yes. The plugin has no latency at any sample rate, so you can play through it while recording and in a live rig, and your DAW needs no compensation for it. The compressor has no lookahead, which is what makes that possible; the price is that after a quiet passage the first strum’s attack can come through a little louder, because it passes at the gain the guitar had just before it. Lower ENHANCE or blend with MIX if it bothers you. The Live & Stage folder has presets for a piezo through a PA: Stage Natural, Stage Even Level for a set with strumming and picking in one song, Stage Warm Full, Stage Bright Cut and Stage Dry Control.

Does it work on a microphone recording, or on other instruments?

It is voiced for a pickup: the body shelf, the quack cut and the softened string zing answer what a pickup gets wrong, and a microphone recording of an acoustic guitar doesn’t have those problems, so the EQ can be more than it needs; the levelling and the room still work, so start at a lower ENHANCE and use MIX. It works on anything close to an acoustic pickup: a nylon-string with a piezo, a mandolin or a ukulele recorded direct, an acoustic preamp’s DI. For an electric bass through a DI, use VEIRA Bass DI Enhancer instead.

VEIRA Guitar DI Enhancer · Help · VEIRA