VEIRA Gate
What is VEIRA Gate for?
VEIRA Gate keeps a track silent (or quieter) when nothing useful is playing and opens the moment something is: the hi-hat spill between snare hits, amp hum between guitar phrases, or room tone between spoken sentences. Its DEBLEED control goes further than a gate can and takes the bleed out of the hits too.
How do I set it up on a snare mic?
Load Drums ▸ Snare Natural (or Snare Tight for a short, dry snare) and drag the amber THRESHOLD line on the waveform into the gap between the bleed and the hits. If the kick still opens the gate, raise KEY LOW; if the hi-hat does, lower KEY HIGH. Check the GATE lane shows one block per hit and none in between.
What do KEY LOW and KEY HIGH do? They don’t change the sound.
That’s right: they filter only what the gate listens to (the key), never the sound you hear. They let you make the gate deaf to bleed, for example KEY LOW 120–180 Hz and KEY HIGH 700 Hz–1 kHz on a snare, so the kick and hi-hat can’t open it. Use KEY LISTEN to hear the key while you adjust, then switch it off.
What does RANGE do, and why does it say Silence?
RANGE sets how far the gate closes. At the default, fully clockwise, it reads Silence (80 dB) and the closed gate outputs exact digital zeros; at 10–20 dB it works as an expander, turning the gaps down but not muting them. If the gate sounds too obvious, try a RANGE of 12–15 dB before touching anything else.
How does DEBLEED work, and how much should I use?
DEBLEED learns what the bleed sounds like while the gate is closed, then turns it down inside the hits as well. Play a section with gaps so it can learn (the LEARNING lamp lights and BLEED LEARNT counts up), then raise DEBLEED to about 30–50 %. More removes more bleed but thins the drum: 100 % costs a snare about 4 dB.
Does VEIRA Gate add latency?
Yes: a fixed 512 samples at 44.1 and 48 kHz (about 11 ms), which is the analysis window DEBLEED needs. Your DAW compensates it automatically and it never changes when you adjust any control, including LOOKAHEAD; for live monitoring through the plugin the delay will be audible.
How do I use EXT KEY for a gated reverb or trance gate?
Insert VEIRA Gate on the track you want to gate, route the key track (for example the dry snare or a 16th-note hi-hat) to its sidechain input, and press EXT KEY; the status box should read KEY: SIDECHAIN. If it reads NO SIDECHAIN, your DAW hasn’t connected the input and the gate is still listening to its own track. Creative FX ▸ Gated Plate and Sidechain ▸ Trance Gate 16ths are ready-made starting points.
Why is my track silent, or why does it sound thin and filtered?
A silent track means the key never reaches THRESHOLD: lower it until the teal key line crosses the amber lines on the hits, and check KEY LOW and KEY HIGH aren’t filtering out the instrument itself. A thin, filtered sound means KEY LISTEN is on; switch it off (offline bounces always leave it out).
Why does the gate chatter, or cut off the start of each hit?
For chatter on long notes, lengthen HOLD and RELEASE, make sure the threshold isn’t sitting on the note’s sustain level, and try a smaller RANGE (10–20 dB). If the start of each hit sounds clipped, raise LOOKAHEAD (4–6 ms for kicks and toms keyed through a low KEY HIGH) and keep ATTACK short.