VEIRA Mastering Exciter
What does VEIRA Mastering Exciter do?
It adds harmonics to a master, band by band, to bring out what is already there: weight under the kick, body in the vocal, presence in the guitars, air on the cymbals. It splits the master into LOW, LOW MID, HIGH MID and HIGH, and each band gets its own colour (TUBE, TAPE, TRANSISTOR or EXACT) and its own DRIVE. The master itself is never filtered: you hear it untouched, plus the colour, and AUTO GAIN keeps the loudness where it was.
How is it different from VEIRA Harmonic Saturator?
VEIRA Harmonic Saturator colours a track with one character, TUBE or EXACT, made from three bands, with a fader for each harmonic; it’s built for instruments and the mix bus. VEIRA Mastering Exciter is built for the master: four bands with a colour of their own each (TUBE, TAPE, TRANSISTOR or EXACT), SOLO per band, DELTA to hear only what it adds, and presets that keep a master’s loudness within 0.02 dB.
Which colour should I use on which band?
TUBE adds warmth and weight (mostly the 2nd harmonic): good on LOW. TAPE adds density and glue (mostly the 3rd). TRANSISTOR adds edge and presence with odd harmonics only: good on HIGH MID, or on LOW to grip a sub. EXACT makes the 2nd, 3rd and 4th exactly and rounds no peak: the usual choice for air on HIGH, and for clean weight or body. A fresh instance (Default ▸ Init) has TUBE, TAPE, TRANSISTOR and EXACT from the bottom band up.
How do I set each band by ear?
Switch on DELTA to hear only what the exciter adds, then SOLO one band at a time and set its DRIVE until the colour helps the music. Then switch both off and compare with bypass: AUTO GAIN keeps the levels matched, so you hear the colour, not the volume. SOLO and DELTA aren’t automatable, so remember to switch them off before you export.
I turn DRIVE and hardly hear a difference. Why?
On a master the colour is meant to be subtle, and AUTO GAIN keeps the loudness where it was. Switch on DELTA to hear what each band adds, or switch AUTO GAIN off for a moment, and check that the band’s ON is lit. TRANSISTOR also stays nearly clean until the music gets loud and then grips the loudest moments: raise its DRIVE, or use TAPE for colour that’s there all the time.
Should it go before or after my limiter?
Before. On a master that’s already limited there’s nothing left to round, so any colour raises the sample peak a little: the mastering presets by up to +0.30 dB. Put VEIRA Mastering Exciter after your EQ and compression and before the limiter, which then catches what it adds.
Why does it add latency?
The four bands are linear phase, so each stays exactly in time and in phase with your master; that costs 1,216 samples at 44.1 and 48 kHz (about 25 ms). Your DAW compensates for it on playback, and when the plugin is bypassed it still delays the signal by the same amount, so the timing stays steady. It’s too much to play through while recording, but on a master or a mix bus you won’t notice it.