VEIRA Bass Rider
What does VEIRA Bass Rider do?
It rides the bass track’s fader for you, the way an engineer rides it through a song. You set TARGET, where the bass should sit in LUFS, and one console fader moves up and down to keep it there: a quiet verse comes up, a hard-hit chorus goes down, within RANGE DOWN and RANGE UP. It evens out sections and passages, not single notes, so the player’s attacks and decays stay as played.
How do I set TARGET?
Start near your bass’s own level, so the fader centres near 0 dB: put the green line on RIDE through the body of the notes, then adjust by ear against the kick and the vocal. K-weighting reads low frequencies quietly, so a bass recorded peaking around −8 dBFS sits around −20 to −32 LUFS: a held synth bass high in that range, slap low. Each preset folder’s TARGET suits its style.
Will it lift an 808’s tail?
No. While a note dies away, the fader holds: the rider follows each note’s body, not its decay. So an 808’s long tail isn’t lifted and the next attack isn’t ducked. With 2-second 808 notes the fader rose 0.00 dB through each tail at the default SPEED. It also holds in the rests and under IGNORE BELOW, so bleed and noise are left alone.
The rider follows single notes. What do I change?
Lower SPEED. The rider is made for sections and passages: low SPEED settings ride sections, high ones phrases and, near the top, single notes. If the player’s accents flatten, or an 808’s pitch steps change its level, SPEED is too high for that part. For note-to-note control, put a compressor after the rider.
Why does a loudness meter read the bass lower than TARGET?
The rider holds the notes’ bodies at TARGET and lets them decay as played, so a meter over the whole bass line reads up to about 1.5 LU lower: little on held synth notes, most on 808s with long tails. Across the factory bank the notes sit within 1.4 LU under TARGET.
Does it add latency?
With LOOKAHEAD on (the default), 25 ms: 1,200 samples at 48 kHz. Your DAW is told and compensates, so the bass stays in time with the kick, also when the plugin is bypassed. LOOKAHEAD lets the rider turn a loud passage down before its first note plays. While recording or monitoring a live bass through the plugin, switch LOOKAHEAD off for zero latency.
How do I record the ride as automation?
Show the track’s automation for Fader (the FADER parameter) and put the track’s automation mode in Touch, Latch or Write. Press WRITE on the rider and play the song: your DAW records every move, about 30 points a second. Then set the track’s automation back to Read and press READ: the fader plays the automation back, and you can edit the lane or drag the fader by hand.