VEIRA Max

What is VEIRA Max for, and where should I put it?

VEIRA Max is a mastering limiter: you turn GAIN up and it keeps every peak under the CEILING you set, using a soft clipper and a lookahead limiter together. Put it last on the master bus, after your EQ and compression, and leave the master fader at 0 dB, because anything after Max can push peaks back over the ceiling.

How do I make a master for streaming at −14 LUFS?

Load Streaming ▸ Streaming -14 LUFS (or Lossy Safe -14 LUFS for a loud, bright mix), click the loudness panel to start a new measurement and play the whole song. Adjust GAIN until INTEGRATED reads about −14 LUFS and AT -14 LUFS reads 0.0, then check that TRUE PEAK MAX stays at or under the ceiling.

How much should I turn up GAIN?

Watch the REDUCTION needle: 1–3 dB on the loudest moments is transparent, 4–6 dB gives a firm, dense master, and 8 dB and more is loud and obviously dense, so listen for flattened drums and distorted bass. The presets assume a premaster around −3 dBFS peak and −16 LUFS integrated; on hotter or quieter material, move GAIN by the same number of dB first.

What does CLIP do?

CLIP (0 to 100 %, default 40 %) moves the work between the soft clipper and the limiter. At 0 % it is all limiter and the cleanest; higher settings are louder and denser with a little edge, and too much clipping can make snares sound papery. On the REDUCTION lane the clipper’s share is drawn in orange and the limiter’s in red.

What is MATCH, and why is my bounce quieter than what I heard?

MATCH plays the output at the input’s loudness so you can hear what limiting does to the sound, not just that it’s louder; its readout shows how much it turns down. Offline bounces always leave MATCH out, but a real-time bounce or recording the output would print it, so turn MATCH off first.

Which CEILING should I use, and why does TRUE PEAK MAX read above it?

The default −1.0 dBTP is what most streaming services ask for; use −2.0 dBTP for loud, bright masters going to lossy formats, and around −0.3 dBTP only for formats never re-encoded, such as a CD. If TRUE PEAK MAX reads above the ceiling, check that TRUE PEAK is on and that nothing comes after Max in the chain (another plugin, the master fader, a pan law).

When should I use dither?

Choose 24 BIT when you bounce a 24-bit master and 16 BIT for a 16-bit master such as a CD; leave NO DITHER for everything else. Dither once, in the last plugin, and don’t add it anywhere else. Max adds its TPDF dither under the ceiling, so it never breaks the true-peak limit.

Does VEIRA Max add latency?

Yes: 224 samples at 48 kHz (the 2 ms lookahead plus the oversampling filters), constant and compensated by your DAW automatically. You may notice it when monitoring live through Max, so use it on the master bus for mixing and mastering, not on a live input.

Why does everything sound flat or distorted?

Too much reduction. Lower GAIN until the needle stays under about 6 dB, then listen at equal loudness with MATCH. If only the bass distorts, lengthen RELEASE or turn AUTO on; if snares sound papery, lower CLIP.