Blog
Practical articles on mixing: what to listen for, where things go in the chain and how much to do, with the VEIRA plugin that does each job.
Mastering with two controls: how loud, and how wideWhat a quick master really needs to decide, why most of mastering can listen to the song and set itself, and how to choose PUSH and WIDEN for streaming, the radio or the club.Read the article →
Mastering in a fixed order: what each step of a mastering chain is forWhy mastering engineers rack their units in the same order, what each step does to a finished mix, and how to take a master to its loudness target without losing what made the mix good.Read the article →
Mastering with one knob: louder in even steps, kept cleanHow to master a song with The Master Knob: match the premaster, turn MASTER until it is as loud as the song needs, compare fairly at the same loudness, and know where a clean limiter stops.Read the article →
Four colours of limiter: clean, punchy, warm and vintage at −6 LUFSWhat a limiter really does to a loud master, why every limiter shapes the peaks at −6 LUFS, and how to choose between a clean, a punchy, a warm and a vintage one by what the mix needs.Read the article →
Limiting a master: loud enough without losing punchHow to set a limiter’s ceiling and gain on a master, how far to push it, how to tell when it starts costing you punch, and why you should compare at matched loudness.Read the article →
Mastering your own song: what goes in the chain, and in which orderWhat each stage of a typical mastering chain does, why the order matters, why the limiter always goes last, and how to compare your master fairly with a reference.Read the article →
Mastering EQ: small, broad moves, left/right and mid/sideHow to EQ a finished mix: why mastering moves are small and broad, where to listen, when mid/side helps, analog versus linear phase, and how to compare fairly.Read the article →
Adding air and presence to a master without making it harshHow harmonic excitement differs from EQ, which bands and amounts tend to work on a master, and how to listen to what you add so the top end opens up without turning harsh.Read the article →
Checking a master before release: what to look at and whyWhat to check on a finished master before it goes out: loudness and true peak for its destination, tonal balance against references, dynamics, stereo and mono.Read the article →