VEIRA Sub Control

A compressor for the low end only, beside a bass enhancer that makes it carry on any speaker.

$49.99, a one-time purchase with free updates

VEIRA Sub Control with the Bass Small Speaker Lift preset while a bass line plays: the LOW END display with the lows’ waveform and the REDUCTION and HARMONICS ADDED lanes, the SPECTRUM with the harmonics in teal, the IN and OUT meters with loudness, and the controls with the REDUCTION needle, COMPRESS at 40 %, HARMONICS at 45 % on TRANSLATE and OUTPUT at 0.0 dB.

VEIRA Sub Control looks after the bottom of a mix: bass lines, 808s, kicks and full mixes. One knob, COMPRESS, evens out everything under 100 Hz and leaves the rest of the track alone, and a second, HARMONICS, adds harmonics of the lows, for weight and grit or so the bass carries on speakers too small to play it.

What sets it apart is that both work the same at any level and never fight the note. COMPRESS follows the low end’s own level, so a setting does the same on a quiet demo as on a loud master, and TRANSLATE adds the exact 2nd to 5th harmonics of the sub, lined up with the note, so a bass line comes through on a phone without its peaks piling up. LISTEN lets you hear just the part it works on, and it adds no latency.

A tour of VEIRA Sub Control

VEIRA Sub Control with the Bass Small Speaker Lift preset while a bass line plays: the LOW END display with the lows’ waveform and the REDUCTION and HARMONICS ADDED lanes, the SPECTRUM with the harmonics in teal, the IN and OUT meters with loudness, and the controls with the REDUCTION needle, COMPRESS at 40 %, HARMONICS at 45 % on TRANSLATE and OUTPUT at 0.0 dB.
  1. The whole of VEIRA Sub Control

    VEIRA Sub Control is a low-end controller. COMPRESS is one knob that evens out everything under 100 Hz without touching anything above it, and HARMONICS adds harmonics of the lows, in percent: WARM saturates them like a tube for weight and grit, and TRANSLATE adds the exact 2nd to 5th harmonics of the sub, so phones and laptops that can’t play it still carry the bass line.

  2. The low end over time

    The last 4 seconds under 100 Hz, out in amber over in in grey, with what COMPRESS takes off and the harmonics added underneath.

  3. Where the harmonics land

    The input, the output and the harmonics on their own, from 20 Hz to 2 kHz. The dashed line marks 100 Hz.

  4. In and out

    Peak and RMS for the input and the output, with short-term and integrated loudness.

  5. Compressor, 100 Hz and below

    The REDUCTION needle and the COMPRESS knob: how much the low end is evened out.

  6. Bass enhancer

    HARMONICS in percent, and WARM or TRANSLATE for the kind of harmonics it adds.

What VEIRA Sub Control does for you

The COMPRESSOR 100 Hz AND BELOW section: the REDUCTION needle meter and the COMPRESS knob at 40 %.

One knob for the low end

COMPRESS evens out everything under 100 Hz: loud notes come down, quiet ones come up, and the usual level stays where it was. It follows the lows’ own long-term level, so the same setting does the same on a quiet track as on a loud one. On a bass line whose notes vary by 12 dB, 50 % leaves 7.3 dB and 100 % leaves 4.4 dB, and the REDUCTION needle shows what it takes off right now.

  • 100 Hz and below only
  • The same at any level
  • 0–18 dB REDUCTION needle
The REDUCTION lane: what COMPRESS takes off each note, on a 0 to −18 dB scale.

Nothing above 100 Hz moves it

COMPRESS listens to the lows through a 24 dB/oct low-pass at 100 Hz, so a snare, a vocal or a cymbal never pumps the bass: loud 1 kHz bursts over a 45 Hz tone move its gain by less than 0.001 dB. It works through a low shelf that makes the full change below about 60 Hz and none from 400 Hz up. The REDUCTION lane draws what it took off over the last 4 seconds.

  • 24 dB/oct detection
  • Nothing changed from 400 Hz
  • No latency
The BASS ENHANCER section: the HARMONICS knob at 45 %, with TRANSLATE lit and WARM off.

Weight and grit, by the percent

HARMONICS adds harmonics of the lows, from 0 to 100 %. WARM saturates them like a tube: even and odd harmonics up to 3 kHz for weight and grit, about 10 dB under the lows at 100 %. Only the harmonics are added, never more of the note itself, so notes from 30 to 95 Hz keep their level within 0.02 dB.

  • WARM or TRANSLATE
  • Notes keep their level
  • No aliasing
The SPECTRUM from 20 Hz to 2 kHz: the output in amber, the input as a light line and the harmonics in teal, with a dashed line at 100 Hz between COMPRESS and HARMONICS.

Bass that carries on a phone

Phones and laptop speakers can’t play a sub, but they can play its harmonics. TRANSLATE adds the exact 2nd to 5th harmonics of the lows, so the bass line is still heard. Each harmonic is set in phase against the note so they don’t pile onto its peaks: on steady notes the peak rises at most 0.2 dB at 25 %. The Small Speakers presets make an 808 line 7 to 9 dB louder on a phone-sized speaker.

  • Exact 2nd–5th harmonics
  • Phase-aligned to the note
  • +7 to +9 dB on a phone
The LOW END display: the lows’ waveform over the last 4 seconds in amber over grey, the REDUCTION lane in red and the HARMONICS ADDED lane in teal.

Watch the low end move

LOW END draws the last 4 seconds of the lows: what goes out in amber and what came in in grey. Underneath, REDUCTION shows what COMPRESS takes off and HARMONICS ADDED how loud the harmonics are. Beside it, SPECTRUM shows the input, the output and the harmonics on their own from 20 Hz to 2 kHz. Hover for the levels at any moment.

  • 4 s of history
  • Spectrum to 2 kHz
  • Hover read-out
The OUTPUT knob at 0.0 dB and the LISTEN button.

Hear only what it works on

LISTEN plays only the lows under 100 Hz and the harmonics, so you hear exactly what Sub Control is working on; it switches itself off in offline bounces. OUTPUT trims the result from −24 to +12 dB. There’s no latency, and with COMPRESS and HARMONICS at 0 % the output is the input, bit for bit.

  • LISTEN
  • Left out of bounces
  • Bit-exact at 0 %
The meter bridge: IN at −6.4 dBFS and OUT at −5.9 dBFS, peak and RMS, with short-term and integrated loudness of −23.2 and −22.1 LUFS, a difference of +1.1 LU.

Levels and loudness, in and out

The meter bridge shows IN and OUT peak and RMS in dBFS, with short-term and integrated loudness and OUT − IN in LU, so you see any level change the low end brings. Click the loudness rows to start a new measurement.

  • Peak and RMS
  • Short-term and integrated LUFS
  • OUT − IN in LU
The preset browser showing Bass: Bass Small Speaker Lift, with previous, next and Save.

68 presets, each one measured

Fourteen folders, from Drums, Bass and Keyboards to Mix Bus and Mastering, plus 808s, Small Speakers (all TRANSLATE) and Creative FX. Every track preset changes the level against bypass by at most 0.22 dB, none peaks above −3 dBFS, and the bass presets take 27 to 46 % off the spread of the lows’ level.

  • 14 folders
  • Save your own
  • Recalled with your session

Get VEIRA Sub Control

Pay once and it’s yours, with every future update included.

VEIRA Sub Control

A compressor for the low end only, beside a bass enhancer that makes it carry on any speaker.

  • Yours to keep: pay once, no subscription
  • Every future update, free for life
  • VST3, AU, Standalone on up to 3 computers
  • Changed your mind? Cancel within 14 days (refunds)
USD

One-time payment, in your cart.

Welcome offer

Get 10% off your first order

Leave your email and we’ll send you a code for 10% off your first order, on any plugins. One code per person.

Specifications

Type
Low-end controller: a compressor for 100 Hz and below (COMPRESS) and a bass enhancer (HARMONICS) with two styles
Compress
0 to 100 %: threshold and ratio (up to 8:1) against the lows’ own long-term level; detection 24 dB/oct under 100 Hz; automatic makeup
Harmonics
0 to 100 %: WARM (even and odd harmonics up to 3 kHz, about 10 dB under the lows at 100 %) or TRANSLATE (the exact 2nd to 5th harmonics, together as loud as the lows at 100 %)
Output
OUTPUT −24 to +12 dB; LISTEN (only the lows and the harmonics; off in bounces)
Latency
None; at COMPRESS and HARMONICS 0 % the output is the input, bit for bit
Metering
REDUCTION needle (0 to 18 dB); LOW END (the lows over 4 s with REDUCTION and HARMONICS ADDED lanes); SPECTRUM 20 Hz to 2 kHz; IN and OUT peak and RMS; short-term and integrated LUFS
Presets
68 factory presets in 14 folders (including 808s, Small Speakers and Creative FX), plus your own
Channels
Mono or stereo
Formats
VST3, AU, Standalone
macOS
macOS 11 or later, Apple silicon or Intel (universal). VST3, AU and Standalone.
Windows
Windows 10 or later, 64-bit. VST3 and Standalone.
Pro Tools
Pro Tools (AAX) versions are built and tested, and arrive once they’re signed for Pro Tools.
Latest version
0.2.0, released October 31, 2026 · What’s new

Read more on the blog: Making bass heard on phones and laptops · Mixing bass and kick together: an even, clear low end

Questions? 9 answers about VEIRA Sub Control

Works well with

VEIRA Multiband Compressor

A six-band compressor with one knob per band, that works the same at any level.

$149.99

VEIRA Comp

A tube-coloured compressor you can read like an instrument.

$149.99

VEIRA Max

A loud, clean mastering limiter that shows every decibel it takes.

$149.99